Turn off the water to the faucet, then open the faucet to relieve the water pressure. Loosen the screw holding the faucet handle, and remove the handle. Take off the escutcheon plate around the faucet by removing the screws holding it in place. Loosen the bonnet nut holding the faucet stem in the housing. Move the faucet handle to the “on” position to relieve any remaining pressure and release any water in the line. Close the drain and place a towel in the sink to protect the surface and catch any dropped parts. Kitchen Faucet Repair: Loosen a stuck screw on a single-handle faucet A single-handle ball-type faucet If the Allen screw is stuck, or if you strip it so it won’t come out, remove the cap with the handle still in place. After removing the screw cover on the faucet handle, use a screwdriver to lift off the actual handle. (If your faucet has a hex screw, you’ll need an 1/8-inch Allen wrench to remove it.) Step 4: Once you lift off the handle, you’ll see a cap and adjusting ring. If water is leaking, tighten the ring with needle-nose pliers. Just pry off the decorative cap on the handle, remove the handle screw, tilt the handle back and pull it off. If there’s a threaded retaining clip holding the cartridge in place, use needle-nose pliers to remove it, and then pull the cartridge straight up. Usually, though, a single-handle cartridge faucet will give you the distinct sensation of the inner cartridge lifting upward when you turn the water on. With ball-type or disc-type faucets, the sensation is of inner parts sliding or rotating. This project discusses only the cartridge-type single-handle faucet. .
DIY leaky faucet repair. Doing your own faucet repair may seem daunting, but once you learn the basics, modern faucets like a Moen faucet repair are fairly easy. In fact, the hardest step to fix a leaky faucet is usually finding the right replacement parts for fixes like a Moen faucet repair. Determine which side of your faucet is leaking by shutting off the water supply valves one at a time. If the leak doesn’t stop after the first valve is turned off, it’s the other line that’s leaking. .